Lexmark X46 Series, Service Manual

Page: 137 / 310

Diagnostic aids
3-31
7014-xxx
EP SETUP
The triangles pointing up or down indicate whether there are additional menus. Touch the up or down arrows to
display these additional menus.
Note: If you make changes, touch Submit to make the change effective.
EP Defaults
This setting is used to restore each printer setting listed in EP SETUP to its factory default value. Sometimes
this is used to help correct print quality problems.
To restore EP Defaults:
1. Touch to select EP Defaults from EP SETUP.
2. Touch to select Restore to reset the values to the factory settings, and touch to select Do Not
Restore to exit without changing the settings.
Touch Back to exit without changing the settings.
Fuser Temperature (Fuser Temp)
This adjustment can be used to help solve some customer problems with paper curl on low-grade papers and
problems with letterheads on some types of media.
The fuser temperature can be adjusted to: Normal, Lower, Lowest. The default is Normal.
Touch Back to return to Diagnostics Menu.
Fuser Page Count
The fuser page count can only be viewed and cannot be changed.
Touch Back to return to Diagnostics Menu.
Warm Up Time
You can change the amount of time the printer warms up before allowing pages to print by changing this
setting from 0 to 5. The factory sets the warm up at 0 or no warm up time. This time period lets the backup roll
heat up and helps reduce curl in some environments.
EP SETUP
EP Defaults
Fuser Temp
Fuser Page Count
Warm Up Time
127
Normal
Submit
Back
Print Contrast Medium
Transfer Medium