Lexmark Pro910 Series, Service Manual

Page: 52 / 118

4-2
Service Manual
Lexmark Pro910 Series
Go Back
Previous
Next
Disassembly
Flowchart
Removal procedures
The following procedures are arranged according to the name of the All-In-One part discussed.
Releasing plastic latches
Many of the parts are held in place with plastic latches. The latches break easily; release them carefully. To
remove such parts, press the hook end of the latch away from the part to which it is latched.
General precautions
Use caution when disassembling and reassembling components. The close proximity of cables to moving parts
makes proper routing a must. When components are removed or replaced, any cables disturbed must be
replaced as closely as possible to their original positions. Before removing any component from the machine, be
sure you note the cable routing.
When servicing the machine:
•
Remove the ink tanks and the printhead.
•
Verify that documents are not stored in memory.
•
Move the print cartridge to the far right to cap the nozzles.
•
Always remove the power cord from the AC wall outlet. Do not RE-BRICK the printer.
•
Use a flat and clean surface.
•
Use only authorized replacement parts.
•
Do not force plastic parts.
CAUTION: SHOCK HAZARD
Remove the power cord from the electrical outlet before you connect or disconnect any cable
or electronic board or assembly for personal safety, and to prevent damage to the printer.
Disconnect any connections between the printer and PCs/peripherals.