Lexmark Pro910 Series, Service Manual, Page: 45 / 118

Diagnostic aids
3-9
Lexmark Pro910 Series
Go Back
Previous
Next
Single Test Page
The test page contains the following information:
•
Code version
•
Date of Release
•
Page Count
•
Short Test Voltage
•
Printhead and Ambient Temperatures
•
Alignment and Media Sense Calibration Information
•
USB serial number
•
Mono/color/photo print head purges and ramps
•
Mono/color/photo print head temperatures
•
Cartridge address lines and data lines.
To print the Single Test Page:
1.
From the Manufacturing Test menu, navigate to Single Test Page .
2.
Touch to cancel printing and return to the Manufacturing Test menu.
Manufacturing Mode
This option activates the Manufacturing Mode. The default setting is Off.
To change this setting:
1.
From Manufacturing Test, navigate to Manufacturing Mode .
2.
Select ON or OFF .
•
Selecting ON will POR the printer into Manufacturing Mode after the next POR.
•
Selecting OFF will POR the printer into user mode after the next POR.
3.
Touch Accept to save the setting, or touch to return to the Manufacturing Test menu without saving
any changes.
Clean Nozzles
This option prints the standard Clean Nozzle Page.
To perform this procedure:
1.
From the Maintenance Test menu, navigate to Clean Nozzles .
2.
Touch or to cancel the procedure and return to the Manufacturing Test menu.
Show Strings
This option allows cycling through all available control panel strings in all languages.
To perform this procedure:
1.
From the Maintenance Test menu, navigate to Show Strings .
2.
Touch Previous or Next to cycle through the strings.
3.
Touch to return to the Manufacturing Test menu.