Lexmark Optra Color 1200, Service Manual

Page: 105 / 245

3-20
Service Manual
5050-001
The power indicator blinks indicating the test is in process. The
printer continually runs the same test until cancelled from the
operator panel (by pressing Return or Stop).
Each time the test finishes, the screen is updated with the result. If
the test passes, then the
Pass Count increments by 1. However, if
the test fails, then one of the following failure messages is displayed
for approximately 3 seconds and then the
Fail Count increments by
1.
Once the maximum pass count or fail count is reached, the test is
stopped, the power indicator is turned on solid, and the final test
results are displayed. Press Return or Stop to exit the test.
Quick Disk Test
Selecting this test runs a disk test that performs a non-destructive
read/write on one block per track on the disk. The test reads one
block on each track, saves the data, and proceeds to write and read
four test patterns to the bytes in the block. If the block is good, then
the saved data is written back to the disk.
The following message is displayed while the test is running. The
Power indicator also blinks while the test is in progress.
If the test passes, the Power indicator is turned on solid and the
following message is displayed. Press Go, Return, or Stop to return
to the DEVICE TESTS screen.
If the test fails, the Power indicator is turned on solid and the
following message is displayed. Press Go, Return, or Stop to return
to the DEVICE TESTS screen.
Quick Disk Test
Testing...
Quick Disk Test
Test Passed
Quick Disk Test
Test Failed