Lexmark MB2236, Service Manual, Page: 199 / 317

Menu item Description
Device Operations
Clear Custom Status
Erase all custom messages.
Scanner Configuration
Scanner Manual Registration
Print Quick Test
Print a Quick Test target page.
Note: Make sure that the margin spacing on the target page
is uniform all the way around the target. If it is not, then the
printer margins may need to be reset.
Scanner Configuration
Scanner Manual Registration
Front ADF Registration
Flatbed Registration
Manually register the flatbed and ADF after replacing the ADF,
scanner glass, or controller board.
Scanner Configuration
Edge Erase
ADF Edge Erase
0–6 (3*)
Flatbed Edge Erase
0–6 (3*)
Set the size, in millimeters, of the no
‑
print area around an ADF
or flatbed scan job.
Scanner Configuration
Disable Scanner
Enabled*
Disabled
ADF Disabled
Disable the scanner if it is not working properly.
Scanner Configuration
Tiff Byte Order
CPU Endianness*
Little Endian
Big Endian
Set the byte order of a TIFF
‑
formatted scan output.
Scanner Configuration
Exact Tiff Rows Per Strip
On*
Off
Set the RowsPerStrip tag value of a TIFF
‑
formatted scan output.
Note: An asterisk (*) next to a value indicates the factory default setting.
Service Engineer menu
Entering Invalid engine mode
This mode allows the printer to load the correct firmware code.
1
Turn off the printer.
2
From the control panel, press and hold 3 , 4 , and 6 while turning on the printer.
3
Release the buttons after 10 seconds.
3400-48x
Service menus
199