Printing photos from a PictBridge-enabled digital camera
PictBridge is a technology available in most digital cameras that lets you print directly from your digital camera without
using a computer.
1
Insert one end of the USB cable into the camera.
Note:
Use only the USB cable that came with the camera.
2
Insert the other end of the cable into the PictBridge port on the front of the printer.
Notes:
•
Make sure that the digital camera is set to the correct USB mode. If the camera USB selection is incorrect,
then the camera is detected as a flash drive, or an error message is displayed on the printer control panel.
For more information, see the documentation that came with the camera.
•
The printer reads only one memory device at a time.
Warning—Potential Damage:
Do not touch any open connector, the memory
device, or the printer in the areas shown while actively printing, reading, or
writing from the memory device. A loss of data can occur.
3
If the PictBridge connection is successful, then the following message appears on the display:
Use PictBridge
Device to choose and print photos. Press OK to select printer default
settings.
4
If you want to change the default print settings:
a
Press
O K
to access the PictBridge menu.
b
Press the arrow buttons to select the paper source, paper setup, photo size, number of photos per page and
print quality. You can also enhance the quality of graphics. Press
O K
each time you make a selection.
Note:
The printer will use the default print settings unless you change the print settings from the camera.
5
See the documentation that came with the camera to begin printing.
Note:
If you insert the USB cable of the PictBridge
‑
enabled camera while the printer is performing another job, then
wait for the job to finish before printing from the camera.
Printing
40
