Action
Yes
No
Step 3
Check if you are using a recommended type of paper.
a
Load paper source with a recommended type of paper.
b
Resend the print job.
Do vertical voids appear on prints?
Go to step 4.
The problem is
solved.
Step 4
a
Remove, and then reinstall the imaging kit.
Warning—Potential Damage:
Do not expose the imaging kit
to direct light for more than 10 minutes. Extended exposure
to light may cause print quality problems.
Warning—Potential Damage:
Do not touch the underside of
the imaging kit. This could damage the imaging kit.
b
Resend the print job.
Do vertical voids appear on prints?
Go to step 5.
The problem is
solved.
Step 5
Replace the imaging kit, and then resend the print job.
Do vertical voids appear on prints?
Contact
The problem is
solved.
Uneven print density
Action
Yes
No
Replace the imaging kit, and then resend the print job.
Is the print density uneven?
Contact
The problem is
solved.
Troubleshooting
186
Summary of Contents for CS410 series
