Lexmark 4500-00 Series, Service Manual

Page: 179 / 246

Repair information
4-1
4500
4. Repair information
Warning: Read the following before handling electronic parts.
Handling electrostatic discharge (ESD)-
sensitive parts
Many electronic products use parts that are known to be sensitive to
electrostatic discharge (ESD). To prevent damage to ESD-sensitive
parts, follow the instructions below in addition to all the usual
precautions, such as turning off power before removing logic boards:
•
Keep the ESD-sensitive part in its original shipping container (a
special “ESD bag”) until you are ready to install the part into the
printer.
•
Make the least-possible movements with your body to prevent an
increase of static electricity from clothing fibers, carpets, and
furniture.
•
Put the ESD wrist strap on your wrist. Connect the wrist band to
the system ground point. This discharges any static electricity in
your body to the printer.
•
Hold the ESD-sensitive part by its edge connector shroud
(cover);
do not
touch its pins. If you are removing a pluggable
module, use the correct tool.
• Do not
place the ESD-sensitive part on the printer cover or on a
metal table; if you need to put down the ESD-sensitive part for
any reason, first put it into its special bag.
•
Machine covers and metal tables are electrical grounds. They
increase the risk of damage because they make a discharge path
from your body through the ESD-sensitive part. (Large metal
objects can be discharge paths without being grounded.)
•
Prevent ESD-sensitive parts from being accidentally touched by
other personnel. Install machine covers when you are not
working on the machine, and
do not
put unprotected ESD-
sensitive parts on a table.
•
If possible, keep all ESD-sensitive parts in a grounded metal
cabinet (case).
•
Be extra careful in working with ESD-sensitive parts when cold-
weather heating is used because low humidity increases static
electricity.