Lexmark 4443-301, Service Manual

Page: 34 / 85

Repair information
4-1
Lexmark S500 Series
4. Repair information
This chapter explains how to make adjustments to the All-In-One and how to remove defective parts.
Warning: Read the following before handling electronic parts.
Handling ESD-sensitive parts
Many electronic products use parts that are known to be sensitive to electrostatic discharge (ESD). To prevent damage
to ESD-sensitive parts, follow the instructions below:
•
Keep the ESD-sensitive part in its original shipping container (a special “ESD bag”) until you are ready to install
the part into the machine.
•
Make as few movements as possible with your body to prevent an increase of static electricity from clothing
fibers, carpets, and furniture.
•
Put the ESD wrist strap on your wrist. Connect the wrist band to the system ground point. This discharges any
static electricity in your body to the machine.
•
Hold the ESD-sensitive part by its edge connector shroud (cover); do not touch its pins. If you are removing a
pluggable module, use the correct tool.
•
Do not place the ESD-sensitive part on the machine cover or on a metal table; if you need to put down the ESD-
sensitive part for any reason, first put it into its special bag.
•
Machine covers and metal tables are electrical grounds. They increase the risk of damage, because they make
a discharge path from your body through the ESD-sensitive part. (Large metal objects can be discharge paths
without being grounded.)
•
Prevent ESD-sensitive parts from being accidentally touched by other personnel. Install machine covers when
you are not working on the machine, and do not put unprotected ESD-sensitive parts on a table.
•
If possible, keep all ESD-sensitive parts in a grounded metal cabinet (case).
•
Be extra careful in working with ESD-sensitive parts when cold-weather heating is used, because low humidity
increases static electricity.