LEXIUM MHDA1004, User Manual, Page: 107 / 204

Chapter 5 System Operation
890 USE 120 00
93
Procedure for Verifying System Operation, continued
Quick Tuning
Procedure This procedure will enable you to rapidly assess the operational readiness of the
system.
Continued on next page
Step Action
1 Disconnect the drive from the power source.
WARNING!
MECHANICAL MOVEMENT HAZARD
Ensure the motor is securely mounted and that the load is disconnected
from the motor.
Failure to observe this precaution can result in severe injury or
equipment damage.
2 Ensure 0 V is applied to the enable input (connector X3, terminal 15).
3 Connect the PC to the drive via the serial communications cable.
4 Turn on the 24 Vdc bias supply. After the initialization procedure
(< 5 seconds) the status is shown in the LED display.
5 Switch on the PC, start the UniLink software and select the serial
communication port to which the drive is connected. (The parameters that
are stored in the SRAM of the drive are transferred to the PC.)
6 Use the UniLink software to check/establish the following:
l
Drive Parameters - Set/restore the drive parameters to the factory
default values
l
Supply voltage - Set the supply voltage to the actual mains supply
voltage
l
Servo Motor - Select the applicable BPH servo motor.
l
Feedback - Ensure the feedback matches the feedback unit in the
servo motor