User Manual for PuraLev
®
iF30SU
www.levitronix.com
PL-4078-00, Rev00, DCO# 20-228
17
4
Installation
4.1 Electrical Installation of Stand-Alone Model
4.1.1 Overview of Connections and Designations
Figure 19: Electrical connections to Stand-Alone driver IPD-30.5
Pin #
Pin
Name
Wire
Color
1
Description
Standard
Designation
2
Specifications
Typical Levels
Note
2
P +
red
+ 24 VDC
Power Supply
Voltage: 24 VDC ±10%
Power: 35 W
“P -“ shall be connected to earth
1
P -
black
Ground/Earth
3
NC
white
Not connected
--
Wire of compatible cables is cut.
Wire of compatible cables is cut.
Table 9: Power supply connector of Stand-Alone driver model
Note 1: Wire colors of compatible cables: ICP-1.1-xx.
Note 2: Designations for standard firmware. For other firmware refer to relevant documentation.
Pin #
1
Pin
Name
Wire
Color
1
Description
Standard
Designation
2
Typical Levels
Note
6
Ain1
pink-blue
Analog Input
Reference
Value
(Set Flow or
Speed)
4..20 mA = 0..100% of full scale flow
4..20 mA = 0..16000 rpm
Speed limit = 13000 rpm
Cutt-off speed = 0 rpm
For
Flow Control
mode.
For
Speed Control
mode.
450 Ohm shunt input, no galvanic isolation.
5
Ain_GND
red
Analog Input
Ground
--
--
Reference for Ain1.
1
Dout1
white
Digital Output
Status Pump
Closed circuit
active, system on
Open circuit
not active, system off
Open drain, max. 24V, 100mA
This signal indicates the state of the system.
3
GND
brown
Ground
--
--
Reference for Dout1.
black
Shield
2
Din1
yellow
Digital Input
PLC Enable
Edge triggered:
0 V
5-24 V
Enable
5-24 V
0 V
Disable
For enabling of the system with external signal.
Galvanic separation with optocoupler and
2.2 k
input resistance.
4
Din_COM
grey
Common
Digital Input
--
--
Reference for Din1.
Table 10: PLC 6 connector of Stand-Alone driver model
Note 1: Screw type connector pin-out and wires of compatible cables ICS-1.3-xx.
Note 2: Designations for standard firmware. For other firmware refer to relevant documentation.
Power Supply
Connector
PLC 6 Connector
Flow Sensor
Connector
Display
User Button
