User Manual for BPS-200
www.levitronix.com
PL-4012-00, Rev07, DCO# 20-144
33
7
Troubleshooting
7.1 Troubleshooting for Operation with Controller LPC-200.1
For troubleshooting and failure analysis with the stand-alone controller
LPC-200.1
the following procedure is
recommended:
◼
Check the status of the LEDs. The specific LEDs are described in
◼
Use the ERROR codes on the display. The specific error codes are described in
◼
A digital output on the “USER INTERFACE” connector (“Status”) indicates if the system is active.
However, the source of an error cannot be identified by this signal
7.2 Troubleshooting for Operation with Controller LPC-200.2
The integrated
PLC
provides a Warning and an Error signals according to
. However, the source of
error cannot be identified by these signals.
For more detailed analysis the
Levitronix
Service Software
can be used with a PC and a USB interface to
the controller.
7.3 Troubleshooting with Levitronix
®
Service Software
The
Levitronix
Service Software
allows communication with the pump system in connection with a PC and a
USB interface. The software can be used for performing detailed troubleshooting.
Note:
Levitronix
Service Software
can not be used with the standalone controller
LPC-200.1
.
8
Technical Support
For troubleshooting, support and detailed technical information contact
Levitronix
Technical Service
Department
:
Levitronix
Technical Service Department
Technoparkstr. 1
CH-8005 Zurich
Switzerland
Phone for US: 888-569 07 18
Phone for outside US: +1 888-569 07 18
E-Mail: Tec[email protected]
