Step 11 - Install control module(s)
• Unpack the control module(s).
• Set the 3 DIP switches labeled S1 on the printed circuit
board (See Figure 6) as follows:
SW1 – down
SW2 – down
SW3 – down
• If the control module is a Remote type, verify that jumper
JP5 is in the “REM” position.
• If the control module is a Universal type, verify that the
AMX/DMX switch is in the DMX position and that the
Status/Other switch is in the “Other" position. See Figure 7.
• Install the appropriate control module in the bottom slot of
each pack by sliding it in until it is fully seated.
STATUS/OTHER SWITCH AMX/DMX SWITCH
NON-DIM SWITCHES
Figure 6 - Remote Control Module
Figure 7 - Universal Control Module
3 GANG DIP SWITCH (S1) JUMPER (JP5) CONTROL FUSES
RACK NO.
THUMBWHEEL
SWITCH
POWER INDICATOR
TEST SWITCH
Module No.
Control Module
Type
120V
240V(Foreign Electric
Service Only)
TOPAZ 12
Remote
LEC2102
LEC2105
TOPAZ 12
Universal
600-902
600-904
Page 7
