Install Cover Panels
35
Install the Power Modules and EMI Shields
1.
Tilt both Power Module holders down to the
ground and rest them on their kickstands
(highlighted).
Note:
The kickstands must rest on a surface
that is level with the bottom of the Express
250.
2.
Install the rear Power Module first. Using two
people, lift the Power Module by its top
handles and gently slide it into its holder
with its connections facing outward (a).
Once the Power Module is positioned
partially inside its holder, fold the handles
down to slide it in completely.
CAUTION:
Power Modules are 45 kg (98.5 lb) each. Two people are needed to install or
replace a Power Module.
CAUTION:
Always rest a Power Module flat on the ground until it is being installed. Power
Modules are not stable in any other position. Images of Power Modules standing up with
the handles on top are only to illustrate the proper installation position.
250_IGcombo.pdf 41
11/18/2019 3:37:41 PM