32
5.
Connect the shortest cable to the top holster.
6.
Connect the next-longest cable to the bottom holster.
Note:
If there is a third, longer cable, bundle it to avoid
pinch points during installation. The third cable is not
currently used.
7.
Reinstall the P-clip hardware stack:
•
Generation 1: holster, star washer, ground cable lug,
P-clip with light power cable routed through, M5
T25 screw head.
•
Generation 2: holster stud, P-clip with light power
cable routed through, nut. Torque the nut to 5.5
Nm (48.7 in-lbs).
Install the Right Extrusion
1.
Slightly tilt the right extrusion and slide its
top edge under the bottom edge of the
area light bar. Align the holes in the
extrusion with the guide pins on each side
of the Express 250’s frame.
Important:
Check that these connections are
correctly seated, or the system will not operate.
250_IGcombo.pdf 38
11/18/2019 3:37:41 PM