Install Cover Panels
31
6.
Use the supplied T25 Torx driver to loosely secure
the middle two screws, just above the Power
Module mechanism.
Note:
Access to the middle screws is easier with the
Power Module mechanism handle in the closed
(down) position.
7.
Tighten all left extrusion screws.
Connect the Right Extrusion’s Holster Light Cables
1.
Locate the P-clip mounted to one of the holsters
(top or bottom holster varies by product version).
2.
Remove the P-clip hardware from the extrusion
holster:
•
Generation 1, attached with screw: use a T25
Torx driver to remove the screw and all its
components. Carefully note the order of the
components.
•
Generation 2, attached with nut (shown): Use an
8 mm nut driver to remove only the nut and the
P-clip.
3.
Identify the holster light cable hanging from the
right side of the dispenser.
4.
Insert the shielded holster cable into the opening
in the P-clip to complete the ground path.
250_IGcombo.pdf 37
11/18/2019 3:37:41 PM