29
4
Install Cover Panels
This section describes how to correctly attach all cover panels. This is required to prevent any
electrical shock hazard before powering on the charging station. These steps are the same for both
Standalone and Paired installations.
Install the Left Extrusion
1.
At the bottom right corner of the Express 250,
press and hold the yellow release latch while
pulling the Power Module tray out of the station.
2.
Carefully lift the charging cables/connectors out
of the Power Module tray and rest them gently
on a padded surface out of the way.
3.
Slightly tilt the left extrusion and slide its top
edge under the bottom edge of the area light
bar. Align the holes in the extrusion with the
guide pins on each side of the Express 250’s
frame. This temporarily holds the extrusion in
place.
250_IGcombo.pdf 35
11/18/2019 3:37:41 PM