Serial Port
Modem Properties Screen
This screen is displayed when the
Modem Properties
button on the
Dial-in
screen (or on the
Serial Port - Internet
sub-screen) is clicked. Normally, it is not necessary to use this screen.
Figure 36: Modem Properties Screen
Data - Modem Properties Screen
Initial String
Initial String
This is a series of AT commands used to correctly configure your
modem or ISDN.
•
The
Initial String
can only be changed for the "Other" modem type.
•
See
Appendix C - AT Commands
for further details about the
required
Initial String
settings and standard AT commands.
Other Properties
Dial Type
Select
Tone
,
Pulse
or
Other
to match your system. For
Other
, you must
provide the
Dial String
.
Dial String
The AT command sent to your modem before dialing. For example,
"ATDT" tells your modem to use Tone Dialing.
Check your modem's documentation to find the correct AT commands.
Auto Answer
Commands
Enter the command strings which turn the "auto-answer" function in
your modem or ISDN TA ON and OFF.
Buttons
Save
Save the data on this screen.
Note that if the current modem was not "Other" type, and you changed
the
Initial String
, you can NOT use "Save". You must use "Save as
Other" instead.
Save as
"Other"
Assign the data shown on screen to the "Other" modem type, regardless
of the modem selected on the
Dial-in
screen.
You should then select "Other" as the Modem to use.
65