LevelOne GEL-1061, User Manual

Page: 91 / 500

Chapter 3
| Basic Management Tasks
Resetting the System
– 91 –
◆
Total – The total amount of system memory.
Web Interface
To display memory utilization:
1.
Click System, then Memory Status.
Figure 27: Displaying Memory Utilization
Resetting the System
Use the System > Reset menu to restart the switch immediately, at a specified time,
after a specified delay, or at a periodic interval.
Command Usage
◆
This command resets the entire system.
◆
When the system is restarted, it will always run the Power-On Self-Test. It will
also retain all configuration information stored in non-volatile memory. (See
“Saving the Running Configuration to a Local File” on page 69 ).
Parameters
The following parameters are displayed:
System Reload Information
◆
Reload Settings – Displays information on the next scheduled reload and
selected reload mode as shown in the following example:
“The switch will be rebooted at March 9 12:00:00 2012. Remaining
Time: 0 days, 2 hours, 46 minutes, 5 seconds.
Reloading switch regularly time: 12:00 everyday.”
◆
Refresh – Refreshes reload information. Changes made through the console or
to system time may need to be refreshed to display the current settings.
◆
Cancel – Cancels the current settings shown in this field.
System Reload Configuration
◆
Reset Mode – Restarts the switch immediately or at the specified time(s).