Chapter 17
| IP Configuration
Setting the Switch’s IP Address (IP Version 6)
– 472 –
Showing the MTU
for Responding
Destinations
Use the System > IPv6 Configuration (Show MTU) page to display the maximum
transmission unit (MTU) cache for destinations that have returned an ICMP packet-
too-big message along with an acceptable MTU to this switch.
Parameters
These parameters are displayed:
Web Interface
To show the MTU reported from other devices:
1.
Click System, IPv6 Configuration.
2.
Select Show MTU from the Action list.
Figure 314: Showing Reported MTU Values
Table 34: Show MTU - display description
Field
Description
MTU
Adjusted MTU contained in the ICMP packet-too-big message returned from this
destination, and now used for all traffic sent along this path.
Since
Time since an ICMP packet-too-big message was received from this destination.
Destination
Address
Address which sent an ICMP packet-too-big message.
Summary of Contents for GEL-1061
