Commissioning steps at a glance
Leuze
electronic
8
BPS 34
Leuze electronic
3
Commissioning steps at a glance
Notice!
Below you will find a
short description for the initial commissioning
of the barcode po-
sitioning system BPS 34. Detailed explanations for all listed points can be found throughout
the handbook.
Mechanical design
Mounting the barcode tape
The barcode tape is to be affixed without tension to a dust- and grease-free mounting
surface.
➔
Mounting the BPS 34 device
There are two different types of mounting arrangements for the BPS 34:
1.
Using 4 M4x6 screws on the rear of the device.
2.
Using a mounting device (BT 56) on the dovetail fastening grooves.
Notice!
The installation dimensions listed in the following figure must absolutely be adhered to. Op-
tically, it must be ensured that the scanner has an unobstructed view of the barcode tape at
all times.
➔
Figure 3.1:
Beam exit and device arrangement of the BPS 34
➔
➀
000200
2
000216
0
000204
000208
0002122
10˚
103 ± 2
10˚
Read distance
Beam exit
all dimensions
in mm
Barcode tape
Centre of the scanning beam
(device centre, output position value)
Scanning beam
10 ° pitch
in the vertical
axis
(dependent on
the tape height,
see notice)
