Leuze electronic CSL710-R05-1280.A/L-M12, Original Operating Instructions, Page: 67 / 98

Example configurations
Leuze electronic CSL 710 67

Map pin 5 to configured height area 2.
10.3 Example configuration - Activating and deactivating blanking areas
10.3.1 Configuration of blanking areas (general)

Perform the following settings to activate or deactivate blanking areas.
Example: automatic blanking of two areas during teaching
Example: Deactivation/resetting of auto blanking
10.4 Example configuration – smoothing
10.4.1 Smoothing configuration (general)

Make the following settings for smoothing.
Example: Smoothing of four interrupted beams
(see table 16.8
(see table 16.9
Description / variables
Configuration of digital inputs/outputs
IO Function Value: 3 = Area output (area 1 … 8) The area output signals the logical states of beam
areas 1 … 8
Description / variables
Configuration of pin 5
Area mapping 8 … 1
(OR combination)
0b00000010
Blanking settings Parameter Number of auto blanking areas : = 2 Two blanking areas permitted
Parameter Auto blanking (during teaching) : = 1 Automatic blanking-area configuration active
System commands Parameter Teach command : = 1 Execute teach command
Blanking settings Parameter Number of auto blanking areas : = 0 No blanking areas permitted
Parameter Auto blanking (during teaching) : = 0 Automatic blanking area configuration not active
Blanking settings Parameter Function for blanking area/logical value
for blanking area 1 :
= 0 No beams blanked
Parameter Function for blanking area/logical value
for blanking area 2:
= 0 No beams blanked
System commands Parameter Teach command : = 1 Execute teach command
Smoothing settings Parameter
Smoothing -– less than i interrupted
beams are ignored
:
= 4 Beams are taken into account in the evaluation once
there are four or more interrupted beams