Display and control panel AMS 338i
Leuze electronic
AMS 338
i
45
TNT
35/7-2
4
V
Notice!
The rear cover
of this manual includes a
fold-out page
with the complete
menu structure
.
It describes the menu items in brief.
8.3.2
Parameter menu
Parameter handling submenu
The following functions can be called up in the
Parameter handling
submenu:
• Lock and enable parameter entry
• Set up a password
• Reset the AMS 338
i
to default settings.
Additional important information on parameter handling can be found at the end of the
chapter.
EtherCAT submenu
Note regarding the second station address - in short SSA- (formerly station alias)
The SSA is a freely configurable position-independent address which is often used for the
so-called hot connect. The values range from 0 to 65535. The SSA is persistently stored on
the AMS 338
i
and is available after the next boot-up. A second option is to write the SSA
to the Eeprom and the associated ESC register via the master (typically TwinCAT). In this
Table 8.1:
Parameter handling submenu
Level 3
Level 4
Level 5
Selection/configuration option
Description
Standard
Parameter
enabling
ON / OFF
The standard setting (
OFF
) prevents unintended parameter changes.
With parameter enabling activated (
ON
), the display is inverted. In this
state, it is possible to change parameters manually.
OFF
Password
Activate
password
ON / OFF
To enter a password, parameter enabling must be activated.
If a password is assigned, changes to the AMS 338
i
can only be made
after the password is entered.
The master password 2301 bridges the individually set password.
OFF
Password
entry
Configuration option of a four-digit numerical password
Parameters to
default
By pressing the enter button
after selecting
Parameters to default
, all parameters are reset to their stan-
dard settings without any further security prompts.
In this case, English is selected as the display language.
Table 8.2:
EtherCAT submenu
Level 3
Level 4
Level 5
Selection/configuration option
Description
Standard
Activation
ON / OFF
ON
Address
(station alias)
Configuration option 0 - 65535
0
