Leuze electronic AMS 200, Technical Description, Page: 94 / 118

Device parameters and interfaces
90 AMS 200 Leuze electronic
8 . 3 .7 Default settings of the AMS 200/…-20…
Table 8.16: Default settings of the Interbus interface
Notice !
The AMS 200 cannot be configured via the Interbus.
The settings labelled with footnote 1) can only be changed via the display. Changed param-
eters are stored in the AMS 200 and are reactivated following power off/on.
Default parameters of the AMS 200/xxx-20-(H)
Interbus activation
1)
1) Parameter can be changed via the control panel/display
ON
RS2 3 2 activation
1)
OFF
Ident-Code 3 2H
Number of data bits 3 2
Data breakdown
2 3 -bit measurement value, 1-bit sign, 2-bit reserved, 3 -bit pre-failure mes-
sages, 2-bit errors, 1-bit statically set to binary 1
Measurement value represen-
tation
1)
Gray
Unit
1)
Metric
Resolution
1)
1mm
Count direction
1)
Positive
I/O 1
1)
Input LOW = laser on, HIGH = laser off
I/O 2
1)
Velocity monitoring output set to > 0.2m/s (configurable)
Static preset
1)
+ 000.000
Dynamic preset
1)
+ 000.000
Pos. limit value range 1
1)
Lower and upper limit, both 000.000
Pos. limit value range 2
1)
Lower and upper limit, both 000.000
Error handling procedures
1)
Position output: 000.000
Position status suppression: active
Error delay time: 100ms
Display language
1)
English
Display illumination
1)
Off after 10 min.
Display contrast
1)
medium
Password protection
1)
Off
Password
1)
0000