Leuze electronic
CMS 700i
– Contour Measurement System
Page 8
The control cabinet of the device may only be opened to insert or remove the software
dongle. See chapter 7.1!
2.3 Competent persons
Connection, mounting, commissioning and adjustment of the device must only be carried out by
competent persons.
Prerequisites for competent persons:
They have a suitable technical education.
They are familiar with the rules and regulations for occupational safety and safety at work.
They are familiar with the original operating instructions of the contour measurement system
CMS 700i and its components.
They have been instructed by the responsible person on the mounting and operation of the
device.
CAUTION
Absolutely observe!
Electrical work may only be carried out by qualified electricians!
Certified electricians
Electrical work must be carried out by a certified electrician.
Due to their technical training, knowledge and experience as well as their familiarity with relevant
standards and regulations, certified electricians are able to perform work on electrical systems and
independently detect possible dangers.
In Germany, certified electricians must fulfill the requirements of accident-prevention regulations
BGV A3 (e.g. electrician foreman). In other countries, there are respective regulations that must be
observed.
2.4 Exception of liability
Leuze electronic GmbH + Co. KG is not liable in the following cases:
The device is not being used properly
Reasonably foreseeable misuse is not taken into account.
Mounting and electrical connection are not properly performed.
Changes (e.g. constructional) are made to the device