Letatwin MAX LM-550A/PC A11, Instruction Manual

Page: 67 / 69

8. TROUBLE SHOOTING
66
Problem Countermeasure
3. When printing on the tape:
1) The tape cannot be set.
2) Does not print.
3) The printing is blur (weak).
4) The printing is stained (too
dense).
5) The tape is shorter than the
setting.
6)
The characters don’t come
to the center.

Check the position of the M roller lever.

Make sure that the tape has been set properly.

Make sure that the setting value for the tape width is correct.

Make sure that the ink ribbon has been set properly.

Make sure that there is no dirt, stain, etc adhered to the tape.

If the ambient temperature becomes lower that 15
℃
or
higher than 35
℃
, printing faults may occur.
Note:
● Try adjusting “
PRINTING DENSITY
” in OPTION menu.

Check that the feeding roller is clean.

Check that there is no waste of the tape or tube caught in the
exit.
Note:
● Try adjusting “CUTTING POSITION”
in OPTION menu.
4. Half cutting does not work.
1) The tape is not cut.
2) The cutting of the tube is
shallow (cannot be cut off).

Make sure that the half cutter has been set properly.

Make sure that the
“Half cutting depth adjustment lever” is
properly set. (TUBE position)

Check the cutter has been worn out or not. If the cutter has
been used more than 5,000 cuttings, replace it with new one.

Make sure to use the exclusive half cutter LM-HC340 (yellow
color).

Check that there is no waste of the tape or tube caught in the
exit.
5. Manual cutting does not work.

Check that there is no waste of the tape or tube caught in the
exit.

Check the manual cutter has been worn out or not. If the
manual cutter has been used more than 30,000 cuttings, ask
your dealer for servicing.
● The manual cutter cannot be replaced by customers.
Contact your dealer for service.
●
In case the problem is not solved with the above countermeasures, contact your dealer for
service.