Mirror Back View
Peel-O�
Film
7
VANITY C VANITY TOP + MIRROR
INSTALLATION STEPS
MIRROR INSTALLATION
Using a tape measure find a length of the vanity
top and divide it by 2. The result of the division
will be a center of the top. Using a tape measure
find the center of the top and mark a dot on the
wall just right above theb top using a pencil.
Using a level tool find a location of a second dot
to draw a vertical line that will serve as
installation center for the mirror.
Measure the distance between installation
brackets of the mirror and divide it by 2. The
result of the division will be a distance between
the drawn center line and center of a drilled
holes. Mark a center of the first hole and using a
level find and mark a location for a second
hole.Using an electric drill make the holes.
See Figure 5
Apply a silicone inside each hole. Insert wall
anchors (a hammer may be needed if the holes
are too tight.) Using a Philips Screwdriver insert
the mounting screws into the wall anchors (do
not screw in completely as the brackets of the
mirror must hang on top of the screws.) Align
the mirror with the wall and carefully hang the
mirror on the screws. Both screw heads must be
inserted into the brackets on the mirror during
hangin process. Make sure that the mirror is
secured safely on the wall.
See Figure 6
Note:
If the brackets can not reach the screws or
the mirror is loose after hanging you need to
adjust the screws using the Philips Screwdriver.
IMPORTANT!
Using a stud finder locate wooden
studs. Screws for mounting mirror must be installed in
the wooden studs to support weight of the mirror.
IMPORTANT:
At the bottom of the back side of the mirror there are two foam blocks
with adhesive surface covered by a film. Remove the film before hanging
the mirror. These blocks will stick to the wall for extra support, leveling,
and preventing from moving.
Figure 5
Figure 6
WALL
WALL
WALL
WALL
www.lesscare.com
VANITY SET:
LV11-24
