1
3
4
Figure 11
Figure 10
Figure 12
www.lesscare.com
LH1-36G & LH2-30G
WALL MOUNT RANGE HOODS
INSTALLATION INSTRUCTIONS
9
INSTALL/REMOVE OIL TRAY
FILTER AND LIGHTS REPLACEMENT
Oil tray is located inside of the range hood, above the
removable aluminum grease filter attached to the bottom
of the motor. Turn off and disconnect the range hood from
the power source. Wear thick gloves prior to removing the
fiter. Find the filter underneath the rangehood. The filter's
open/close lock is located in the center on the rigt side of
the filter. Using your finger press the lock's button and
carefully pull the filter down while holding the oposite side
of the filter with another hand to prevent from falling down.
Filter is now removed. Locate the installation space at the
bottom of the motor. Slide in the plastic oil tray forward
until it stops. Make sure that the holes on the bottom of the
motor are centered by the tray.
Important Note:
Incorrect installation of the tray or if the
tray is not installed will cause the oil to drip through the
range hood on top of the range and will cause fire. Timely
cleaning of the oil tray is required. Check the oil tray at least
once a week to make sure it will not overflow when full.
See Figure 10
Turn off and disconnect the range hood from the power
source
.
Wear thick gloves prior to removing the fiter. Find
the filter underneath the rangehood. The filter's
open/close lock is located in the center on the rigt side of
the filter. Using your finger press the lock's button and
carefull pull the filter down. Filter is now removed.
See Figure 11
Wear thick gloves prior to removing the LED module.
After removing the filter push the LED modules through
the mounting holes.
See Figure 12
2
