www.lesscare.com
4
LB7B
BASIN FAUCET
INSTALLATION INSTRUCTIONS
You should clean all the dirts from valve
outlets. Turning off the water supply
valves. This is usually found near the water
meter. If you are replacing an existing
faucet, remove the faucet from the sink
and clean the sink surface thoroughly.
Place Mounting Nut, Metal Washer and
Rubber Washer over Valve Shank. From
underside sink, insert valve body through
mounting holes. The hot valve, labeled with
red tag should be positioned to the left side
of the spout.
From underneath sink, tighten Mounting
Nut by Hand. Before final tightening, make
sure Valve Body Side Connector facing
Spout Body.
Connect Spout hot water flexble hoses to
the Left Valve Side Connector. Tighten
flexible hoses Nut. Connect Spout cold
water supply line to the right Valve Side
Connector.
Make sure the O-Ring is in side the Joint,
and connect the Joint to the main body.
Connect hot and cold water flexible hoses
to faucets inlets.
As shown. lnsert Flange with Washer
through Sink drain Hole. From underside,
thread Drain Body into Flange. Holding the
drain body in position with Ball Rod
Opening facing back, tighten Metal
Locknut securely. Thread Drain Tailpiece
into Drain body.
By rotating the handle closed to the spout,
the Valve will be activated allowing water
to flow. The water flow will increase by
continuing to rotate handle .By rotating
the right handle to the left, the water
temperature will decrease to cold flow
only. By rotating handle left to the right,
the water temperature will increase to hot
only.
After installation is complete, remove
aerator and rotate handle to the close
position. Turn on the Water Supply Valves,
and check all connections for leak. Turn on
your faucet and allow both hot and cold
water to run at least one minute each.
Replace Aerator.
1
2
4
5
6
7
9
8
3
90
90
Close
Hot
Close
Cold
Open
Open
