Lepu Medical AIView 12V, Operator'S Manual, Page: 52 / 292

3-17
When a parameter is switched off, no measurements and alarms are
provided.
3.11.3 Configuring the Normal Screen Layout
You can configure the parameter numerics, waveforms, and their
sequence displayed on the normal screen. To do so, please refer to
the following steps:
1. Access [Layout] screen in either of the following ways:

Press the [Screens] quick key
→
select the [Layout] tab.

Press[Main Menu]
→
[Screens], select the [Layout] tab.
2. Select a parameter area and select an element to be displayed
in this area from the pop-up list. The parameters and waveforms
not selected will not be displayed on the screen.
Note
ECG parameters and the first ECG waveform are always displayed on the
first line of the parameter area and waveform area.
Note
Turn off all other parameters except ECG parameter, then the screen can
display an ECG signal within a vertical space of 30mm per ECG channel.
3.11.4 Setting Monitoring Parameters
Each parameter has its own setup menu to allow adjusting of the
alarm and parameter settings.
Access [Parameters] screen in either of the following ways:

Select the parameter numeric area of a parameter.
 Press the [Parameters] quick key.

Press [Main Menu]
→
[Parameters].
Select the desired parameter. For details of each parameter setting,
please refer to the respective parameter setup menu description in
corresponding parameter measurement chapters.
3.11.5 Setting the Beat Mode
To set the beat mode, follow the steps below:
1. Press [Main Menu]
→
[System]
→
[System] to enter the system
setup screen.
2. Set the [Beat] mode. Options: Mode 1, Mode 2.
The frequency of heart beat in the two modes is different, so it is
convenient for users to distinguish.