12
MOUNTING INSTALLATION
Wall Mounting
Follow the steps below to mount the industrial Ethernet switch to a wall using the screw holes as shown
below in Figure 3.1.
Figure 3.1: The Rear Side of the Switch
Follow the steps below to learn how to hang the industrial Switch.
Step 1.
Prepare 4 screws for mounting the switch to a wall.
Note: Recommended use the M5 screws.
Step 2.
Based on the Figure 3.2: Physical Dimensions which is shown the positions of 4 screw holes on the
left and right side of the switch to make 4 screw holes on a wall accordingly.
Step 3.
Insert the screws through the screw holes on the switch and screw the switch into the wall. Shown
above in Figure 3.1.
Step 4.
To remove the switch from the wall, do the opposite from the steps above.
Note: Make sure disconnect all cables from the switch before removing the unit from the wall.
Figure 3.2: Position of the screw holes
