Lenze MOBILE Advanced DCU, Hardware Manual

Page: 63 / 76

Installation
Connections of MOBILE DCU S
Motor
5
Ò
63
EDSMDAG EN 2.0
5.7.3 Motor
X3 V
max
[V AC] [mm
2
]
[
AWG
]
1 2 3
1 U
600
2.5
12
2 V
3 W
EMDAG049c
ƒ
In addition, a equipotential bonding between motor and DC/AC inverter is required.
ƒ
Install the equipotential bonding conductor in parallel to the motor cable.
5.7.4 Control system
X1 Description
1 4 7 16 13 19 1 0
1 CAN_H Public CAN and Private CAN network
2 CAN_L
3 CAN_L_TERM Bus terminating resistor for CAN
4 n.c. Do not use
5 Analog thermal sensor
6 TEMP_MA−
7 TRM15 Switch on/off device
8 TRM30 Supply voltage for control electronics
9 CAN_H Public CAN and Private CAN network
10 CAN_L
11 FLX_IN4 Digital inputs
12 FLX_IN3
13 n.c. Do not use
14 SWUP Secondary Wake up
15 TRM31 Vehicle mass, negative pole of the vehicle battery
16 FLX_IN1 Digital inputs
17 FLX_IN2
18 ID_PIN1
Address offset for setting the CAN address
19 ID_PIN2
20 ID_PIN3
EMDAG049a 21 n.c. Do not use