General information
Thermal power limit
The thermal power limit, defined by the heat balance, limits the permissible continuous
gearbox power. It is affected by
•
the churning losses in the lubricant. These are determined by the mounting position and
the circumferential speed of the gears
•
the load and the speed spectrum.
•
the ambient conditions: temperature, air circulation, input or dissipation of heat via shafts
and the foundations.
NOTICE
A thermal check with the Drive Solution Designer (DSD) or contacting your Lenze
representative is required if
▶
the input speed n
1
> 1500 rpm is fallen below in case of the gearbox ratios given in the
following.
▶
the drive speeds mentioned in the following will be exceeded as a function of the mounting
position. For a short period of time up to 5 min, 30 % higher speeds are permissible.
▶
the ambient temperature is predominantly above +30 °C.
Gearboxes
Ratio i
g500-H850 ... H3000
≤ 50
Motor
Mounting position M1
Mounting position M3, M5, M6
Mounting position M2, M4
m850-S120
4000 rpm
3500 rpm
3000 rpm
m850-S140/S190
3000 rpm
2600 rpm
1500 rpm
Possible ways of extending the application area
•
Shaft sealing ring made of FKM material/Viton (option)
•
Reducing the lubricant amount (after consultation with Lenze)
•
Cooling the geared motor by air convection on the machine/system
Information on project planning
General information
21
Summary of Contents for g500-H100
Page 1: ...Geared servo motors g500 H m850 helical geared servo motor Project planning EN...
Page 2: ......
Page 155: ......
Page 156: ...06 2021 2 0 www Lenze com...