Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Changing and saving parameters
18
EDKVF93−05 EN 2.0
Action
Key
sequence
Step
Display of SHPRG or SHPRG
Confirm change to accept the parameter
Display "OK"
Display
−
The parameter has been accepted immediately
8.
Enable the controller, if required
#
1)
The drive runs again
9.
Change to the code level
A
Display of the operating level
B
Display of the code with changed parameter
10. Change further parameters
Restart the "loop" with step 1. or 3.
11. Save changed parameters
A
! "
Select the code C0003 "PAR SAVE" in the menu
"Load/Store"
B
Change to the parameter level
Display "0" and "READY"
Select the parameter set in which
the parameters are to be saved
permanently
C
Save as parameter set 1:
ð
Set "1" "Save PS1"
Save as parameter set 2:
ð
Set "2" "Save PS2"
Save as parameter set 3:
ð
Set "3" "Save PS3"
Save as parameter set 4:
ð
Set "4" "Save PS4"
D
When "OK" is displayed, the settings are permanently
saved in the selected parameter set.
12. Change to the code level
A
Display of the operating level
B
Display of C0003 "PAR SAVE"
13. Set parameters for another parameter
set
Restart the "loop" with step 1. or 3.
1)
The function of the
$
key can be programmed:
C0469 = 1: Controller inhibit
C0469 = 2: Quick stop (Lenze setting)