Lenze 8400 motec Series, Software Manual, Page: 303 / 376

Firmware
≤
02.00 - DMS 2.1 EN - 03/2011
L
303
8400 motec | Software Manual
Parameter reference
Parameter list | C02607
C02607
C02610
Parameter | Name:
C02607 | Holding brake: Status
Data type: UNSIGNED_16
Index: 21968
d
= 55D0
h
Switching status of the holding brake control
Holding brake control
Display area
(min. hex value | max. hex value)
0x0000 0xFFFF
Value is bit-coded: Info
Bit 0 Brake closed Holding brake is completely applied
Bit 1 Brake released Holding brake is completely released
Bit 2 Feedforward control active Feedforward control for holding of the load via the motor
is active before the holding brake releases.
Bit 3 Closing active The brake application time ( C02589/1 ) expires
Bit 4 Forced release active In case of automatic operation of the holding brake
control, the brake is directly released via the MCK input
bBrkRelease = TRUE
Bit 5 Release active The brake application time ( C02589/2 ) expires
Bit 6 Setpoint synchronisation active A speed setpoint at the MCK is approached along a
defined ramp after brake release
Bit 7 Brake control fault Motor phase error detected before brake is released. For
configuration of monitoring see C00597 .
Bit 8 Reserved
Bit 9 Reserved
Bit 10 Reserved
Bit 11 Reserved
Bit 12 Reserved
Bit 13 Reserved
Bit 14 Reserved
Bit 15 Reserved
;
Read access Write access CINH PLC STOP
;
No transfer COM MOT
Parameter | Name:
C02610 | MCK: Accel./deceleration times
Data type: UNSIGNED_32
Index: 21965
d
= 55CD
h
From version 02.00.00
Ramp times for speed setpoint synchronisation
Setting range
(min. value | unit | max. value)
0.0 s 999.9
Subcodes Lenze setting Info
C02610/1 2.0 s MCK: Holding brake ramp time synchr.
• Ramp time for approaching the speed setpoint
pending at the MCK after the holding brake release
has been completed.
Holding brake control
;
Read access
;
Write access CINH PLC STOP No transfer COM MOT Scaling factor: 1000