Lenovo ThinkSystem SR645, Setup Manual

Page: 143 / 188

2. Connect the super capacitor module to an adapter with the extension cable that comes with the super
capacitor module.
Install the RAID super capacitor module on the air baffle
Use this information to install the RAID super capacitor module on the air baffle.
About this task
Attention:
• Read “Installation guidelines” on page 92 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DY1RaWHYM4xDloAwuBQHR0
• Youku: http://list.youku.com/albumlist/show/id_52339628
Procedure
Step 1. Touch the static-protective package that contains the RAID super capacitor module to any
unpainted surface on the outside of the server. Then, take the RAID super capacitor module out of
the package and place it on a static-protective surface.
Step 2. Install the RAID super capacitor module on the air baffle.
Figure 64. Installation of the RAID super capacitor module on the air baffle
a. Open the retention clip on the holder.
b. Put the RAID super capacitor module into the air baffle and press it down to secure it into the
air baffle.
After you finish
1. Install the air baffle on the chassis. See “Install the air baffle” on page 147.
Chapter 4
.
Server hardware setup
139