Lenovo ThinkSystem SR530, Maintenance Manual

Page: 145 / 184

Install the system board
Use this information to install the system board.
“
Read
the
installation
Guidelines” on
page 45
“
Power off
the server
for this task”
on page 14
“
ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 48
Before installing the system board, touch the static-protective package that contains the new system board
to any unpainted surface on the outside of the server. Then, take the new system board out of the package
and place it on a static-protective surface.
Watch the procedure
. A video of the installation process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-AQrHuDWK6L3KtHWc6maY_O
• Youku:
http://list.youku.com/albumlist/show/id_50437162
To install the system board, complete the following steps:
Step 1. Grasp the system board by the release pin
1
and the lift handle
2
at the same time, and tilt the
system board at an angle of approximately 20 degrees as shown.
Step 2. Align the hole
3
on the system board with the corresponding mounting stud
5
on the chassis first,
and then align the hole
4
by the same way.
Note:
Before you align the two holes, prevent the system board from touching the mounting studs
on the chassis.
Step 3. Lower the system board into the chassis and slide it to the rear of the chassis until it clicks into
position.
Step 4. Install the four screws in the following sequence.
Chapter 3
.
Hardware replacement procedures
137