Lenovo ThinkSystem NE2552E, Application Manual

Page: 504 / 574

504
NE2552E Application Guide for ENOS 8.4
Using Juniper Perl Client
You can use Juniper Perl client instead of BNClient to communicate with the
NETCONF feature on the switch. Follow these steps to use the Juniper Perl client.
Note:
You must use the Linux operating system for the Juniper Perl client.
1.
Extract the file
juniper-netconf-perl-client.zip
to the folder
/home/user/
.
You will see two folders:

juniper-netconf-perl-client

blade-netconf-perl-scripts
2.
Follow these steps to install the Juniper Perl client:
As a Perl library:
a.
Change to the following directory:
/home/user/juniper-netconf-perl-client
b.
Extract the following file:
netconf-perl-10.0R2.10.tar.gz
c.
Change to the following directory:
/home/user/juniper-netconf-perl-client/netconf-perl-10.0R
2.10
d.
Install the client as per the instructions in the
README
file.
Note:
If the prerequisites package installation fails, manually install each file in
/home/user/juniper-netconf-perl-client\netconf-perl-prereqs-
patch
.
As a Perl script:
a.
Change to the following directory:
/home/user/blade-netconf-perl-scripts/
b.
Enter the following command:
Note:
get.pl
is an example of a NETCONF operation Perl script. You can edit the
script or write a new script as per your requirement.
perl get/get.pl -l admin -p admin
{swich IP address}