Lenovo ThinkServer TD350, User Manual And Hardware Maintenance Manual

Page: 177 / 226

11. Position the new AnyRAID adapter near the backplane. Then, carefully press the new AnyRAID adapter
straight into the AnyRAID-adapter slots until it is securely seated. Tighten the two screws to secure the
new AnyRAID adapter in place.
Figure 132. Installing the AnyRAID adapter
12. Reinstall the AnyRAID-adapter air duct (if available).
13. Reconnect the cables. See “Connecting cables” on page 44.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the replacement procedure, go to “Completing the parts replacement” on page 180.
Replacing the hot-swap-drive backplane
Attention: Do not open your server or attempt any repair before reading and understanding “Read this first: safety
information” on page iii and “Guidelines” on page 69.
This topic applies only to server models that have hot-swap internal storage drives installed.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Notes:
• The hot-swap-drive backplane is sensitive to ESD. Ensure that you read and understand “Handling
static-sensitive devices” on page 70 first and carefully perform the operation.
• Depending on the model, your server might look slightly different from the illustrations in this topic.
• Use any documentation that comes with the new hot-swap-drive backplane and follow those instructions
in addition to the instructions in this topic.
To replace the hot-swap-drive backplane, do the following:
Chapter 6
.
Replacing hardware
163