Lenovo ThinkServer RD350G, User Manual And Hardware Maintenance Manual

Page: 149 / 186

9. Align the screw holes in the new riser card with the corresponding ones in the bracket. Then, install the
two screws to secure the riser card to the bracket.
Figure 112. Installing the riser card
10. Reinstall the PCIe card on the new riser card assembly.
11. Position the new riser card assembly on the chassis and align it with the riser card slot on the system
board. Align the mounting studs on the system board with the corresponding holes in the riser card
assembly. Then, carefully press the riser card assembly straight down into the chassis until it is fully
seated.
Figure 113. Installing the riser card assembly
12. Reinstall any parts or reconnect any cables that you have removed.
13. If you are instructed to return the old riser card assembly, follow all packaging instructions and use any
packaging materials that are supplied to you for shipping.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the replacement, go to “Completing the parts replacement” on page 142.
Replacing the coin-cell battery
Chapter 6
.
Replacing hardware
135
your eading and
page and page