To pair your computer with an NFC-enabled smartphone:
Before you start, ensure that the smartphone screen is facing upward.
1. Tap the smartphone on the NFC touchpoint as shown.
2. Slowly move the smartphone in the upright direction within a 10 mm (0.39 inches) distance. Then hold
the smartphone for seconds until you are prompted that the smartphone has been successfully
detected.
Enabling the NFC feature
In case that the NFC feature of your computer is disabled, do the following to enable the NFC feature:
1. Open the Start menu .
2. Tap
Settings
➙
Network & Internet
➙
Airplane mode
.
3. Tap the
NFC
control to turn it on.
If you still cannot enable the NFC feature, check the
NFC
setting in the ThinkPad Tablet Setup app by doing
the following:
1. Open the ThinkPad Tablet Setup app. See “ThinkPad Tablet Setup app” on page 43.
2. Tap
Security
➙
I/O Port Access
.
3. Set the
NFC
option to
On
.
Using a microSD card
Your computer has a nano-SIM-card and microSD card slot on the left side of the computer. The slot
supports the following types of Secure Digital (SD) cards:
• Secure Digital eXtended-Capacity (SDXC) card
• Secure Digital (SD) card
• Secure Digital High-Capacity (SDHC) card
This section provides the basic instructions on installing and removing the microSD card. For more
information about data transfer, refer to the documentation of the microSD card.
Attention:
16
User Guide
Summary of Contents for THINKPAD X1 Tablet Gen 3
