Lenovo ThinkPad E590, User Manual

Page: 66 / 106

Error messages
If you see a message that is not included in the following table, record the error message first, then shut
down the computer and call Lenovo for help. See “Lenovo Customer Support Center” on page 63.
Message
Solution
0190: Critical low-battery error
The computer turned off because the battery power is low. Connect the
ac power adapter to the computer and charge the batteries.
0191: System Security - Invalid remote
change requested The system configuration change has failed. Confirm the operation and
try again.
0199: System Security - Security
password retry count exceeded.
This message is displayed when you enter a wrong supervisor password
more than three times. Confirm the supervisor password and try again.
0271: Check Date and Time settings.
The date or the time is not set in the computer. Enter the BIOS menu and
set the date and time.
1802: Unauthorized network card is
plugged in - Power off and remove the
network card.
The wireless network card is not supported on this computer. Replace
with a supported wireless network card.
1820: More than one external fingerprint
readers are attached.
Turn off and remove all but the reader that you set up within your main
operating system.
210x/211x: Detection/Read error on
HDDx/SSDx
The storage drive is not working. Reinstall the storage drive. If the
problem still exists, replace the storage drive.
Error: The non-volatile system UEFI
variable storage is nearly full.
Note:
This error indicates that the operating system or programs cannot create,
modify, or delete data in the non-volatile system UEFI variable storage
due to insufficient storage space after POST.
The non-volatile system UEFI variable storage is used by the UEFI BIOS
and by the operating system or programs. This error occurs when the
operating system or programs store large amounts of data in the variable
storage. All data needed for POST, such as UEFI BIOS setup settings,
chipset, or platform configuration data, are stored in a separate UEFI
variable storage.
Press F1 after the error message is displayed to enter the BIOS menu. A
dialog asks for confirmation to clean up the storage. If you select “Yes”,
all data that were created by the operating system or programs will be
deleted except global variables defined by the Unified Extensible
Firmware Interface Specification. If you select “No”, all data will be kept,
but the operating system or programs will not be able to create, modify,
or delete data in the storage.
If this error happens at a service center, Lenovo authorized service
personnel will clean up the non-volatile system UEFI variable storage
using the preceding solution.
60
E590 and R590 User Guide