Lenovo System x3650 M4 HD, Installation And Service Manual

Page: 103 / 1168

Power
cable
Configuration
cable
Backplane
Power
cable
Configuration
cable
Backplane
Backplane
Configuration
cable
Power
cable
Mini-SAS cable
Mini-SAS cable
Mini-SAS cable
Figure 82. Backplanes cable connection
Step 11. Install the hard disk drives (see “Installing a hot-swap drive” on page 42).
Step 12. Install the 2.5-inch HDD fillers into empty drives.
If you have other devices to install or remove, do so now. Otherwise, go to “Completing the installation”
on page 94.
Installing the 16x1.8-inch SSD assembly kit
Use this information to install the 16x1.8-inch SSD assembly kit.
To order the 16x1.8-inch SSD assembly kit, contact your Lenovo sales representative or Lenovo reseller.
The 16x1.8-inch SSD assembly kit contains the following components:
• Two 1.8-inch solid-state-drive backplane assemblies
• One power cable
• One configuration cable
• Four mini-SAS cables (820 mm)
To install the 16x1.8-inch SSD assembly kit in the server, complete the following steps.
Step 1. Read the safety information that begins on “Safety” on page v and “Installation guidelines”
on page 34.
Step 2. Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 3. Remove the cover (see “Removing the cover” on page 37).
Step 4. Remove the two 4-drive filler panels from the right side.
Chapter 2
.
Installing optional devices
91