Lenovo System x3630 M4, Installation And Service Manual

Page: 193 / 1050

00000
00000
00000
00000
00000
0000
0000
0000
Filler panel
Driver-tray
assembly
Drive handle
Step 5. Make sure that the tray handle is open.
Step 6. Align the drive assembly with the guide rails in the bay.
Step 7. Gently push the drive assembly into the bay until the drive stops.
Step 8. Push the tray handle to the closed (locked) position.
Step 9. If the system is turned on, check the hard disk drive status LED to verify that the hard disk drive
is operating correctly.
After you replace a failed hard disk drive, the green activity LED flashes as the disk spins up. The yellow LED
turns off after approximately 1 minute. If the new drive starts to rebuild, the yellow LED flashes slowly, and
the green activity LED remains lit during the rebuild process. If the yellow LED remains lit, see “Hard disk
drive problems” on page 143.
Note: You might have to reconfigure the disk arrays after you install hard disk drives. See the RAID
documentation on the ServeRAID Support CD for information about RAID controllers.
Removing a simple-swap hard disk drive
Use this information to remove a simple-swap hard disk drive.
To remove a simple-swap hard disk drive, complete the following steps:
Step 1. Read the safety information that begins in “Safety” on page v, “Handling static-sensitive devices”
on page 38 and “Installation guidelines” on page 36.
Step 2. Turn off the server (see “Turning off the server” on page 26) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
Step 3. Remove the filler panel from the front of the server.
Step 4. Locate the release tab (blue) on the hard disk drive; then, while you press the release tab to the
right, grasp the handle and pull the drive out of the bay.
Chapter 6
.
Removing and replacing components
179