Lenovo System x3630 M4, Installation And Service Manual

Page: 192 / 1050

00000
00000
00000
00000
00000
Driver-tray
assembly
Drive handle
Step 3. Grasp the handle and pull the hot-swap drive assembly out of the drive bay.
Step 4. If you are instructed to return the hot-swap drive, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Replacing a hot-swap hard disk drive
Use this information to replace a hot-swap hard disk drive.
The following notes describe the type of hard disk drives that the server supports and other information
that you must consider when you install a drive.
• Locate the documentation that comes with the hard disk drive and follow those instructions in addition to
the instructions in this chapter.
• Depending on the server configuration, your server may support up to eight 3.5-inch hot-swap SAS/SATA
hard disk drives or fourteen 3.5-inch hot-swap SAS/SATA hard disk drives (for this configuration two
3.5-inch hot-swap SAS/SATA hard disk drives are located at the rear of the server). For a list of the
supported hard disk drives, see http://www.lenovo.com/ serverproven/.
• All hot-swap drives in the server should have the same throughput speed rating. Using hard disk drives
with different speed ratings will cause all drives to operate at the throughput speed of the slowest drive.
To install a hot-swap SAS or SATA drive, complete the following steps:
Important: Do not install a SCSI hard disk drive in this server.
Step 1. Read the safety information that begins in “Safety” on page v, “Handling static-sensitive devices”
on page 38 and “Installation guidelines” on page 36.
Step 2. Touch the static-protective package that contains the drive to any unpainted metal surface on the
server; then, remove the drive from the package and place it on a static-protective surface.
Step 3. Remove the filler panel from the front of the server.
Step 4. Orient the drive as shown in the illustration.
178
Lenovo System x3630 M4 Installation and Service Guide