• Hardware configuration (print screen of the system summary)
• UEFI firmware level
• IMM firmware level
• Operating-system software
You can solve some problems by comparing the configuration and software setups between working and
nonworking servers. When you compare servers to each other for diagnostic purposes, consider them
identical only if all the following factors are exactly the same in all the servers:
• Machine type and model
• UEFI firmware level
• IMM firmware level
• Adapters and attachments, in the same locations
• Address jumpers, terminators, and cabling
• Software versions and levels
• Diagnostic program type and version level
• Setup utility settings
• Operating-system control-file setup
See Appendix D “Getting help and technical assistance” on page 1013 for information about calling Lenovo
for service.
Recovering the server firmware
Use this information to recover the server firmware.
Important:
Some cluster solutions require specific code levels or coordinated code updates. If the device
is part of a cluster solution, verify that the latest level of code is supported for the cluster solution before
you update the code.
If the server firmware has become corrupted, such as from a power failure during an update, you can
recover the server firmware in either of two ways:
•
In-band method:
Recover server firmware, using either the boot block jumper (Automated Boot
Recovery) and a server Firmware Update Package Service Pack.
•
Out-of-band method:
Use the IMM Web interface to update the firmware, using the latest server
firmware update package.
Notes:
You can obtain a server update package from one of the following sources:
• Download the server firmware update from the World Wide Web.
• Contact your Lenovo service representative.
To download the server firmware update package from the World Wide Web, go to
http://www.lenovo.com/support.
The flash memory of the server consists of a primary bank and a backup bank. You must maintain a bootable
System x Server Firmware (server firmware) image in the backup bank. If the server firmware in the primary
bank becomes corrupted, you can either manually boot the backup bank with the boot block jumper, or in
the case of image corruption, this will occur automatically with the Automated Boot Recovery function.
158
Lenovo System x3630 M4 Installation and Service Guide
Summary of Contents for System x3630 M4
