Lenovo System x3630 M4, Installation And Service Manual

Page: 106 / 1050

Rotating the optional hot-swap rear hard disk drive cage down
Use this information to rotate the optional hot-swap rear hard disk drive cage down.
To rotate the optional hot-swap hard disk drive cage down, complete the following steps.
Step 1. Read the safety information that begins in “Safety” on page v and “Installation guidelines” on
page 36.
Step 2. Shift the switch on the rear hard disk drive cage to the unlock position 1 .
Step 3. Slowly rotate the cage downwards until it sits into place 2 .
Step 4. Close the blue latches on the chassis 3 .
00
00
00
00
00
00
00
00
0
00
00000
00000
00000
00000
00000
000
000
2
3
3
1
Release latch
If you have other devices to install or remove, do so now. Otherwise, go to “Completing the installation”
on page 87.
Installing the server top cover
Use this information to install the server top cover.
To install the server cover, complete the following steps:
Step 1. Make sure that all cables, adapters, and other components are installed and seated correctly
and that you have not left loose tools or parts inside the server. Also, make sure that all internal
cables are correctly routed.
Step 2. Align the cover over the server (toward the rear of the server) until the cover edges slip into
position over the chassis.
Attention: Before sliding the cover forward, make sure that all the tabs on both the front, rear,
and side of the cover engage the chassis correctly. If all the tabs do not engage the chassis
correctly, it will be hard to remove the cover later.
Step 3. Slide the cover forward toward the front of the server until the cover is completely closed.
92
Lenovo System x3630 M4 Installation and Service Guide