Lenovo S510, Hardware Maintenance Manual

Page: 104 / 142

6. Remove the four screws at the rear of the chassis that secure the power supply assembly. Slide the
power supply assembly to the front of the computer and then lift it out of the chassis.
Figure 33. Removing the power supply assembly
7. Ensure that the new power supply assembly is the correct replacement.
8. Install the new power supply assembly into the chassis so that the screw holes in the power supply
assembly align with those in the chassis.
9. Install and tighten the four screws to secure the power supply assembly.
Note: Use only screws provided by Lenovo.
10. Reconnect the power supply assembly cables to the system board. See “Parts on the system board”
on page 34.
11. Reinstall the optical drive. See “Replacing the optical drive” on page 87.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 113.
Replacing the coin-cell battery
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 “Read this first: Important safety information” on page 1.
Your computer has a special type of memory that maintains the date, time, and settings for built-in features,
such as parallel-connector assignments (configuration). A coin-cell battery keeps this information active
when you turn off the computer.
The coin-cell battery normally requires no charging or maintenance throughout its life; however, no coin-cell
battery lasts forever. If the coin-cell battery fails, the date, time, and configuration information (including
passwords) are lost. An error message is displayed when you turn on the computer.
Refer to the “Lithium coin-cell battery notice” in the Safety and Warranty Guide for information about
replacing and disposing of the coin-cell battery.
To replace the coin-cell battery, do the following:
98
Lenovo S510 Hardware Maintenance Manual