Lenovo RackSwitch G8264CS, Cli Command Reference

Page: 489 / 702

© Copyright Lenovo 2017 Chapter 4: Configuration Commands
489
OSPF Interface Configuration
The following table describes the OSPF Interface commands.
Table 269.
OSPF Interface Configuration Options
Command Syntax and Usage
ip ospf area
<0 ‐ 5>
Configures the OSPF area index.
Command mode: Interface IP
ip ospf cost
<1 ‐ 65535>
Configures cost set for the selected path—preferred or backup. Usually the
cost is inversely proportional to the bandwidth of the interface. Low cost
indicates high bandwidth.
Command mode: Interface IP
ip ospf dead ­ interval
<1 ‐ 65535>
ip ospf dead ­ interval
<1000 ‐ 65535 ms>
Configures the health parameters of a
hello
packet, in seconds or
milliseconds, before declaring a silent router to be down.
Command mode: Interface IP
[no] ip ospf enable
Enables or disables the OSPF interface.
Command mode: Interface IP
ip ospf hello ­ interval
<1 ‐ 65535>
ip ospf hello ­ interval
<50 ‐ 65535 ms>
Configures the interval, in seconds or milliseconds, between the
hello
packets for the interfaces.
Command mode: Interface IP
ip ospf key
<key string>
Sets the authentication key to clear the password.
Command mode: Interface IP
no ip ospf key
Removes the authentification key to clear the password.
Command mode: Interface IP
ip ospf message ­ digest ­ key
<1 ‐ 255>
Assigns an MD5 key to the interface.
Command mode: Interface IP
no ip ospf message ­ digest ­ key
Removes the MD5 key form the interface.
Command mode: Interface IP