Lenovo NeXtScale nx360 M5, Installation And Service Manual, Page: 178 / 1022

After you install the hard disk drive backplate, complete the following steps:
1. Install the cover onto the compute node (see “Installing the compute node cover” on page 115 for
instructions).
2. Install the compute node into the chassis (see “Installing a compute node in a chassis” on page 105
for instructions).
Removing and installing drives
Use this information to remove and install drives.
The following notes describe the type of hard disk drives that the server supports and other information
that you must consider when you install a hard disk drive. For a list of supported hard disk drives, see
http://www.lenovo.com/ serverproven/.
• Locate the documentation that comes with the hard disk drive and follow those instructions in addition to
the instructions in this chapter.
• Make sure that you have all the cables and other equipment that are specified in the documentation that
comes with the drive.
• Select the bay in which you want to install the drive.
• Check the instructions that come with the drive to determine whether you have to set any switches or
jumpers on the drive. If you are installing a SAS or SATA hard disk drive, be sure to set the SAS or
SATA ID for that device.
• The compute node supports up to two 2.5-inch hot-swap SFF, one 3.5-inch, two 2.5-inch, easy-swap
SAS or SATA hard disk drives, or four 1.8-inch solid-state drives.
• For a complete list of supported optional devices for the server, see http://www.lenovo.com/
serverproven/.
Removing a 3.5-inch hard disk drive
Use this information to remove a 3.5-inch SAS/SATA hard disk drive.
To remove a 3.5-inch SAS/SATA hard disk drive, complete the following steps.
Step 1. Read “Safety” on page v and “Installation guidelines” on page 101.
Step 2. If the compute node is installed in a NeXtScale n1200 Enclosure, remove it (see “Removing a
compute node from a chassis” on page 104 for instructions).
Step 3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node
with the bezel pointing toward you.
Step 4. Remove the cover (see “Removing the compute node cover” on page 113).
Step 5. Press down the release latch.
Step 6. Push outward and lift the hard disk drive out of the bay.
164
Lenovo NeXtScale nx360 M5 Installation and Service Guide